A proposito di seedpine1

Descrizione:

Find Out What Peugeot Keys Tricks The Celebs Are Using
Peugeot 208 Key Replacement

It is better to leave the replacement of Peugeot keys for 208 to auto locksmiths that have the right equipment and know-how. They can make and program new keys much quicker than a dealership and at a lower cost.

A dead battery for your coin is the most likely cause the reason why your key fob isn't locking or unlocking the doors. However, there are many other reasons why the key might be malfunctioning.

Dead Coin Battery

A dead coin battery can hinder your Peugeot 208 from locking or unlocking and cannot start the engine. In this situation, you will need to employ the alternate method of starting described in your vehicle owner's manual.

The spark plugs may also be worn out. The spark plugs light the fuel to start the engine. However, they have a limited life span. They'll eventually degrade in the event that they aren't utilized enough.

Luckily, there is an easy solution for this problem. Check the voltage of the battery using a multimeter. If it's lower than 11.5 Volts then you must replace it. If the battery is corroded it is necessary to clean its contacts. This can be done by lifting the rubber covers that protect the two terminals of the battery and using wire brushes to clean any corroded areas of the battery. Then, you should reconnect the positive and negative pole cables.

Water Damage

If your 208 doesn't start and the battery has not been replaced, you must look at the spark plugs. It is possible that they're dirty, causing them not to spark. This can be fixed by cleaning the spark plugs in an workshop.

Peugeot automobiles use a key with a transponder that is compatible with the immobiliser. This ensures that only a valid key is able to turn the engine. If the chip inside the Peugeot key is damaged, then it will not send the correct signal to the vehicle.


Water damage is a common cause of this problem. This is a typical issue in more cold climates where the car is exposed to rain or snow. In this instance, you should contact an experienced locksmith who will have the necessary tools and equipment to reprogram the key. They will also have the most up-to-date technology and equipment needed to make the Peugeot 208 smart key. The process shouldn't take more than 15 minutes.

Contacts of the battery may be damaged.

Peugeot replaced the old transponder chips with a brand new model that is based on electronic components that are mounted on a circuitboard. The new system works great when it's new, but the circuit boards deteriorate over time and cease to function properly.

This can prevent the immobiliser chip activating which means that your car won't start. Contact a Peugeot specialist or a locksmith if this is the situation.

Another issue that is common is when the battery for the key fob is dying, this causes the blade of the key to stop feeding into the lock. A locksmith for cars will replace the battery, and then cut a new key blade for you. This is a simple solution.

Faulty Receiver Module

It could be that the receiver module is malfunctioning when your Peugeot key fob isn't working after being dropped on the floor, exposed to a stormy rainstorm, or accidentally washed. The receiver is responsible for transmitting radio frequency signals to an on-board computer, which controls the central locking system within your Peugeot vehicle.

The rubber seals on the key fob keep water from reaching its electronic chip. Water can damage the chip if it is exposed to water for long periods of period of. The high salt content of the ocean water or pool can cause damage to the key fob when it is submerged.

The module will have to be replaced if your Peugeot spare key no longer works. This can only by done by an Peugeot specialist or an expert auto locksmith. Unlike other cars, Peugeot keys are protected by an exclusive immobilizer system that requires the right coding in order to start the engine. This is why it is imperative that you should only trust an authorized Peugeot locksmith to create and program a replacement.

Computers with faulty on-board computers

The on-board computer in your Peugeot is responsible for a variety of features in your car, including power windows and airbags. The computer on board will display the code when something goes wrong. This code will be stored in the system until the issue is resolved. This can often mean that the on-board computers to be replaced.

peugeot 107 key fob of the main causes of the light turning on is loose or corroded connectors in the airbag sensor. This can occur due to wear and tear, ageing or exposure to moisture and salt. This issue must be dealt with as soon as you can, since an airbag that is not functioning could pose danger in the event of an accident.

If you encounter an error message stating that the card is not found on your Peugeot, the key battery in the key fob could be dead or weak. This will stop the key fob from sending a signal that will disable the immobilizer in your vehicle. You can test this by pressing the unlock button on the key fob and then attempting to start your vehicle. If it doesn't work, the key battery needs to be replaced.