A proposito di jacketchange4

Descrizione:

Peugeot 308 Key Fob: The Good, The Bad, And The Ugly
Peugeot 308 Key Fob Replacement

Peugeot's 308 may be slightly old but it's still eye-catching. It's not the most luxurious car in its class, but it is an enjoyable and relaxing drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. If the issue is persistent or intermittent these tips will help.

Water Damage

If you leave your fob in the midst of a puddle or get it wet when kayaking, swimming, canoeing, rafting, or canyoning, it's more likely to be damaged by water. Keep your key fob in a dry bag every time you are outside or perform activities that expose it to excessive water.

It's also crucial to make sure that the fob is completely dried out before you open it to use it again. If you notice any odors coming from the fob, like an industrial liquid smell or that of windshield washer fluid, it's another indication that it's been submerged in water.

A circuit board that is wet could cause the battery to discharge its charge or even explode. If you're able to fish your key fob 308 out of the water in which it was stuck in it, flip the button side down and shake out as much water as you can before opening the case. After opening it, take out the battery, and then clean the circuit board with an abrasive soaked in 90 percent isopropyl alcohol.

Other reasons your Peugeot 308 remote keyless entry system might stop working include a dead battery for your coin or receiver module issue, signal interference, or an electronic chip that is defective. If none of the above is the problem you can restart the system by removing the 12 Volt battery from the vehicle for 15 minutes.

Dead Coin Battery

Peugeot cars come with remote start systems that allows drivers to start their vehicle from a distance, allowing them to warm up or cool down the vehicle prior to entering. This feature is extremely helpful particularly during the winter's cold and chilly months. However, sometimes the remote start system ceases functioning due to a variety of reasons, such as a dead coin battery.

A coin-shaped battery that is found inside the key fob has a lifespan of two to four years, depending on how often it's used and where it is purchased. The date of use is typically printed on the packaging or written in the manual.

If the key fob has stopped working after being exposed to pure tapwater, you need to remove the battery and clean the electronic chip with the aid of a towel soaked in isopropyl ethanol. Then, dry the chip thoroughly before replacing. In case of exposure to salty or soapy water, the chip could be damaged and you'll need to replace the key fob in total.

If you're not sure the battery is in good condition, you can test its voltage with an instrument set to the car's voltage range. Connect it to the minus and plus terminals. The Keylab should read approximately 12-13 volts, but if it is lower, the battery should be replaced. You can also try to reset the onboard computer by disconnecting the battery at 12 volts for a couple of minutes, and reconnecting it in reverse order (positive cable first, then negative). The engine should begin to run after this.

Faulty Receiver Module

If you're unable to see the "Key Detected" message on your dashboard, it's possible that the receiver module has developed a fault. It is the part that sends out an alert when the key fob turns on. It also acts as an alarm and blocks the car from starting if you don't have the correct key.


It could be due to a number of causes, such as water damage or just ageing. If your Peugeot 308 key fob has been exposed dirty tap water, like the chip that is located on the inside will be damaged. In this case you will need to remove it and thoroughly clean it using isopropyl or electronic cleaner. Once it's dry, you can put the battery back in and test it again.

If the problem persists it is a good idea to see a local Peugeot expert or locksmith. They can utilize an instrument for diagnosing to identify the issue and then fix it.

It can be a stressful experience to lose your Peugeot car key. However, a reputable auto locksmith can solve the issue in just a few minutes. They can program your car and cut a new, functioning key for you. Click here to locate locksmiths near you.

Faulty Electronic Chip

The electronic chip that is in the Peugeot 308 key fob is a very vital component of the remote control system. If the chip is damaged, you could encounter issues starting your car or receive a message stating "anti-theft". If this occurs, the only solution to fix the problem is to get a new key. Professional auto locksmiths are able to provide this fastest possible time.

The chip in your Peugeot 308 key fob can be damaged due to water damage, sweat, dirt or other reasons. If your Peugeot key fob has been exposed dirty or soapy water, it should be cleaned right away. You can wipe the electronic component using a paper towel soaked in isopropyl Alcohol. The battery should be allowed to dry completely.

Radio interference can cause the key fob to stop working. This can be caused when other devices use the same frequency as your Peugeot keyfob. It could be caused by unsafe conditions or objects that are in the vicinity of the vehicle. It is recommended that you visit a Peugeot dealer if you experience this problem.

The Peugeot Key Fob 207/308 is fragile and requires special attention. It is not recommended to drop it or throw it around. If you lose something, try to find it as soon as possible. You can reset the onboard computer by disconnection of the battery for a couple of minutes. Be sure to disconnect the negative cable first, then the positive.